Replacing The Rma - Sun Microsystems Sun Ultra 60 Service Manual

Caution -
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Position the diskette drive into the RMA (Figure 9–3).
2. Using a number 2 Phillips-head screwdriver, replace the four screws securing
the diskette drive to the RMA.
3. Replace the RMA.
See Section 9.2.6 "Replacing the RMA" on page 9-9
9.2.6

Replacing the RMA

Caution -
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Replace the RMA as follows (Figure 9–2):
a. Position the RMA into the chassis, connect the rear cable connectors as
b. Using a number 2 Phillips-head screwdriver, tighten the captive screws
2. Replace the front bezel.
3. Connect the AC power cord.
4. Detach the wrist strap.
5. Replace the side access cover.
See Section 7.3 "Replacing the Side Access Cover" on page 7-5.
6. Power on the system unit.
See Section 6.1 "Powering On the System Unit" on page 6-1.
Use proper ESD grounding techniques when handling components. Wear
Use proper ESD grounding techniques when handling components. Wear
required.
securing the RMA to the chassis.
9-9
Storage Devices