Sun Microsystems Sun Ultra 60 Service Manual page 92

Caution -
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
3. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-3.
4. Remove the SCSI drive bay as follows (Figure 8–4):
a. Remove the hard drive(s).
b. Disconnect the SCSI cables from the motherboard connectors.
c. Disconnect the peripheral power cable.
d. Remove the peripheral power cable from the cable routing clips.
e. Remove the diskette drive cable from the plastic spring clips installed
f. Unfeed the peripheral power cable through the chassis opening.
g. Using a number 2 Phillips-head screwdriver, remove the screws securing the
h. Feed the SCSI cable under the PCI fan bracket while pulling up in Step g.
i. Slide the SCSI drive bay out of the chassis.
Sun Ultra 60 Service Manual ♦ March 1999, Revision A
8-8
Use proper ESD grounding techniques when handling components. Wear
See Section 9.1.1 "Removing a Hard Drive" on page 9-1.
adjacent to the drive bay.
SCSI drive bay to the chassis.