Replacing The Power Supply - Sun Microsystems Sun Ultra 60 Service Manual

Figure 8–1
8.1.2

Replacing the Power Supply

Caution -
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Replace the power supply as follows (Figure 8–1 and Figure 8–2):
a. Feed the power supply cables through the chassis opening; support the
b. Position the power supply into the chassis.
c. Slide the power supply toward the chassis front.
d. Connect the power cables to the motherboard.
e. Connect the peripheral cable connector to the power supply.
Removing and Replacing the Power Supply (Part 1 of 2)
Use proper ESD grounding techniques when handling components. Wear
power supply cables while engaging the power supply into the chassis rails.
8-3
Major Subassemblies