Sun Microsystems Sun Ultra 60 Service Manual page 135

See Section 7.1 "Removing the Side Access Cover" on page 7-1.
Caution - Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
4. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-3.
5. Remove the UPA graphics card as follows (Figure 10–4):
a. Using a Phillips-head screwdriver, remove the screw securing the graphics
card bracket tab to the system unit chassis.
Caution - Avoid applying force to one end or one side of the board or connector
damage may occur.
b. At the two upper corners of the graphics card, pull the card straight up from
the slot.
c. Remove the UPA graphics card.
6. Place the UPA graphics card on an antistatic mat.
Motherboard and Component Replacement
10-11