Removing The Diskette Drive; Replacing The Diskette Drive - Sun Microsystems Sun Ultra 60 Service Manual

Caution -
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Position the CD-ROM drive or tape drive into the RMA (Figure 9–3).
2. Using a number 2 Phillips-head screwdriver, replace the four screws securing
the CD-ROM drive or tape drive to the RMA.
3. Replace the RMA.
See Section 9.2.6 "Replacing the RMA" on page 9-9
9.2.4

Removing the Diskette Drive

Caution -
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Position the diskette drive.
2. Using a number 2 Phillips-head screwdriver, remove the four screws securing
the diskette drive to the RMA (Figure 9–3).
3. Remove the diskette drive and place it on an antistatic mat.
9.2.5

Replacing the Diskette Drive

Note -
power cable and all data cables are properly routed through the clips adjacent to the
drive bay. Route the diskette drive cable through both plastic spring clips installed
adjacent to the hard disk drive bay.
Sun Ultra 60 Service Manual ♦ March 1999, Revision A
9-8
Use proper ESD grounding techniques when handling components. Wear
Use proper ESD grounding techniques when handling components. Wear
If installing a diskette drive (verses replacing), ensure that the peripheral