Figure 10–2
10.2.2
Replacing the NVRAM/TOD
Caution -
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
1. Replace the NVRAM/TOD as follows (Figure 10–2):
a. Position the NVRAM/TOD and carrier on the motherboard.
b. Carefully insert the NVRAM/TOD and carrier into the socket.
Sun Ultra 60 Service Manual ♦ March 1999, Revision A
10-6
Removing and Replacing the NVRAM/TOD
Use proper ESD grounding techniques when handling components. Wear
Note -
The carrier is keyed so the NVRAM/TOD can be installed only one
way.