5. When POST is completed, disconnect the tip window as follows:
a. Open a shell window.
b. Type ps -a to view the active tip line and process ID (PID) number.
c. Type the following to kill the tip hardwire process.
3.2.2
Verifying the Baud Rate
To verify the baud rate between the system unit being tested and a terminal or
another Sun workstation monitor:
1. Open a Shell window.
2. Type eeprom.
3. Verify the following serial port default settings as follows:
Note -
workstation monitor settings.
3.3
Initializing POST
POST is initilized in two ways:
Sun Ultra 60 Service Manual ♦ March 1999, Revision A
3-4
% kill -9 PID#
ttyb-mode = 9600,8,n,1
ttya-mode = 9600,8,n,1
Ensure that the settings are consistent with TTY-type terminal or