Removing The Cpu Module - Sun Microsystems Sun Ultra 60 Service Manual

10.1.1

Removing the CPU Module

1. Power off the system unit.
See Section 6.2 "Powering Off the System Unit" on page 6-3.
2. Remove the side access cover.
See Section 7.1 "Removing the Side Access Cover" on page 7-1.
Caution -
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
3. Attach a wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-3.
4. Remove the CPU module as follows (Figure 10–1):
a. Using the thumbs of both hands, simultaneously lift the two levers on the
b. Lift the CPU module upward until it clears the system unit chassis.
5. Place the CPU module on an antistatic mat.
Sun Ultra 60 Service Manual ♦ March 1999, Revision A
10-2
Use proper ESD grounding techniques when handling components. Wear
CPU module upward and to the side to approximately 135 degrees.