Speaker Assembly; Removing The Speaker Assembly - Sun Microsystems Sun Ultra 60 Service Manual

8.7

Speaker Assembly

To remove and replace the speaker assembly, proceed as follows.
8.7.1

Removing the Speaker Assembly

1. Power off the system unit.
See Section 6.2 "Powering Off the System Unit" on page 6-3
2. Remove the side access cover.
See Section 7.1 "Removing the Side Access Cover" on page 7-1
Caution -
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
3. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-3.
4. Remove the PCI fan assembly.
See Section 8.2.1 "Removing the PCI Fan Assembly" on page 8-5
5. Disconnect the speaker cable from the motherboard (Figure 8–8).
6. Using a number 2 Phillips-head screwdriver, remove the screw securing the
speaker assembly to the chassis.
7. Remove the speaker assembly.
Sun Ultra 60 Service Manual ♦ March 1999, Revision A
8-18
Use proper ESD grounding techniques when handling components. Wear