InfiniBand FDR Switch Platform Hardware User Manual
5. The shelf comes with the four brackets pre-installed. Two of the brackets should be
loose. They may need to be removed and repositioned to meet the distance between
the vertical supports of the rack.
6. Move the shelf brackets on the shelf. Place the shelf bracket so that it measures
slightly more than the measured distance between the vertical rack supports. Make
sure that there is enough play in the bracket so that it can move to the vertical support.
Do not tighten the hex head bolts.
Mellanox Technologies
Figure 7: Adjustable Shelf Brackets
You may need to remove the brackets and reinstall them.
Figure 8: Placing the Shelf Bracket
Adjusting slots
These two brackets
need to be adjusted.
They may even need
to be removed and
repositioned.
The holes in the bracket are
offset to one side.
The holes must be closer to
the top of the shelf.
Rev 1.7
25