InfiniBand FDR Switch Platform Hardware User Manual
7. Insert five nuts into the rack for each of the four shelf brackets (the 2 brackets that
are adjustable and the 2 that are fixed). Make sure that the caged nuts are all at the
same height on the vertical supports. Do not use the top hole in the bracket.
8. Insert 4 caged nuts (two on right and 2 on the left of the spine side) for the bottom
filler panel.
9. Put the Shelf into the rack and twist the shelf into place. Make sure the spine side of
the shelf is closest to the rack doors. See Figure 10 to identify the spine side of the
shelf.
10. Install and tighten the 20 M6 bolts into the caged nuts.
The spine
side of the
shelf has two
slots for the
extension
Adjustable
shelf brackets
11. Tighten the 16 hex head bolts on the adjustable brackets.
Mellanox Technologies
Figure 9: Caged Nut Locations for the Shelf Brackets
Figure 10: Shelf Brackets
Rev 1.7
26