InfiniBand FDR Switch Platform Hardware User Manual
3. On the spine side of the chassis, remove the cover to the power supply unit for the
non-working PSU. Odd numbered PSUs are on the left side and even numbered PSUs
are on the right side facing the spines.There are four phillips head screws for the
cover plate.
Handle
4. Grasping the handle with one hand, push the black latch release while pulling the
handle outward. As the PSU unseats, the PSU status indicators will turn off.
5. Remove the PSU.
To insert a PSU:
1. Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
2. Insert the PSU by sliding it into the opening until a slight resistance is felt.
3. Continue pressing the PSU until it seats completely. The latch will snap into place
confirming the proper installation.
Mellanox Technologies
Figure 33: PSU and Outlet Locations
Figure 34: Power Supply
DC
OK
FAIL
AC
OK
Rev 1.7
Latch
42