Re-Running The Wizard; Starting The Command Line (Cli) - Mellanox Technologies MSX6536-10R Hardware Installation Manual
648-port infiniband fdr switchx switch platform
Hide thumbs
Also See for MSX6536-10R:
- Dismantling manual (14 pages) ,
- Hardware installation manual (52 pages)
Table of Contents
Advertisement
InfiniBand Switch Platform Hardware User Manual
Check the mgmt0 interface configuration before attempting a remote (for example,
Step 5.
SSH) connection to the switch. Specifically, verify the existence of an IP address.
4.2
Re-Running the Wizard
To rerun the wizard:
Enter the config mode.
Step 1.
Rerun the wizard.
Step 2.
4.3
Starting the Command Line (CLI)
Set up an Ethernet connection between the switch and a local network machine using a
Step 1.
standard RJ-45 connector.
Start a remote secured shell (SSH) to the switch using the command "ssh -l <user-
Step 2.
name> <switch ip address>."
Login to the switch (default username is admin, password admin)
Step 3.
Read and accept the EULA when prompted.
Step 4.
Mellanox Technologies
switch # show interfaces mgmt0
Interface mgmt0 state
Admin up:
yes
Link up:
yes
IP address:
169.254.15.134
Netmask:
255.255.0.0
IPv6 enabled:
yes
Autoconf enabled:
yes
Autoconf route:
yes
Autoconf privacy:
no
IPv6 addresses:
1
IPv6 address:
fe80::202:c9ff:fe11:a1b2/64
Speed:
1000Mb/s (auto)
Duplex:
full (auto)
Interface type:
ethernet
Interface source:
physical
MTU:
1500
HW address:
00:02:C9:11:A1:B2
Comment:
RX bytes:
11700449
RX packets:
55753
RX mcast packets: 0
RX discards:
0
RX errors:
0
RX overruns:
0
RX frame:
0
TX queue len:
1000
switch > enable
switch # config terminal
switch (config) # configuration jump-start
rem_mach1 > ssh -l <username> <ip address>
TX bytes:
15139846
TX packets:
28452
TX discards:
0
TX errors:
0
TX overruns:
0
TX carrier:
0
TX collisions: 0
76
Advertisement
Table of Contents
