Mellanox Technologies MSX6536-10R Hardware Installation Manual page 73

InfiniBand Switch Platform Hardware User Manual
Table 17 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 2 of 2)
Wizard Session Display (Example)
Step 4: Enable IPv6 autoconfig (SLAAC) on
mgmt0 interface
Step 5: Admin password (Press <Enter> to
leave unchanged)? <new_password>
Step 4: Confirm admin password?
<new_password>
You have entered the following information:
1. Hostname: <switch name>
2. Use DHCP on mgmt0 interface: yes
3. Enable IPv6: yes
4. Enable IPv6 autoconfig (SLAAC) on mgmt0
interface: yes
5. Admin password (Enter to leave unchanged):
(CHANGED)
To change an answer, enter the step number to
return to.
Otherwise hit <enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
To return to the wizard from the CLI, enter the
"configuration jump-start" command from
configuration mode. Launching CLI...
<switch name> [standalone: master] >
Mellanox Technologies
Comments
Perform this step to enable StateLess address
autoconfig on external management port.
If you wish to enable it, type "yes" and press
<Enter>.
If you wish to disable it, enter "no".
To avoid illegal access to the machine, please
type a password and then press <Enter>. Then
confirm the password by re-entering it.
Note that password characters are not printed.
The wizard displays a summary of your
choices and then asks you to confirm the
choices or to re-edit them.
Either press <Enter> to save changes and exit,
or enter the configuration step number that you
wish to return to.
Note:
To run the command "configuration jump-
start" you must be in Config mode.
73