InfiniBand FDR Switch Platform Hardware User Manual
- 32 lock washers – 20 for the lock down
bars and 12 for the upper brackets to
upper bracket offsets
- 2 upper brackets
- 1 open end ratchet wrench 10mm
- 1 socket wrench
- 2 extensions for the socket driver
- 4 flat washers for the shelf extension
- Bottom filler panel
•
Parts included in the cable management installation kit:
- 1 cable management rack RH
- 16 caged nuts M6
- 9 cable management shelves
Shelf extension
Upper bracket
washer
Upper bracket
1.7.3.3 Container Mishandling
The container has shock and tilt stickers applied. These will turn red if the container has
been mishandled or roughly handled. Upon receipt of the container look for and inspect
the shock and tilt stickers to confirm that they have not tripped. If one or more are red
notify the shipper and Mellanox. This on its own does not indicate damage to the con-
tents. But, be sure to carefully inspect the contents if any of the shock and tilt stickers
have tripped.
Mellanox Technologies
Figure 2: Installation Kit Parts
Shelf
Upper bracket offset
- 12 flat head screws for the upper bracket
offsets
- 1 socket nut driver 8mm
- 1 socket nut driver 10mm
- 1 socket nut driver 14mm
- 1 box wrench
- 6 two hole lock washers for lock down bars
- Top filler panel
- 1 cable management rack LH
- 16 M6 bolts
Lock-down bar
Flat head screws with
locktite
#6 hex head bolt
Phillips pan head
screw
#8 hex head bolt
Caged nuts
Lock washers
Lock washers
Flat washers
Flat washers
20
Rev 1.7