Attach the left and right rack mount brackets (B) to the switch, by gently pushing the switch
Step 3.
chassis' pins through the slider key holes, until locking occurs. Secure the system in the
brackets by screwing the remaining 2 flat head Phillips screws (E) in the designated points
with a torque of 1.5±0.2 Nm. See
Install 8 cage nuts in the desired 1U slots of the rack: 4 cage nuts in the non-extractable side
Step 4.
(in the top and bottom holes only) and 4 cage nuts in the extractable side.
Rev 1.9
Figure 12: Attaching the Rails to the Chassis
Figure
Figure 13: Attaching the Brackets to the Chassis
Mellanox Technologies
13.
Installation
25