1.10.5 Management Module - Mellanox Technologies MSX6536-10R Hardware Installation Manual

648-port infiniband fdr switchx switch platform
Hide thumbs Also See for MSX6536-10R:
Table of Contents

Advertisement

InfiniBand FDR Switch Platform Hardware User Manual
Inserting the Spine Fan Module
1. Make sure the fan module is oriented correctly top side up. Confirm that the location
of the connector in the chassis will line up with the connector in the fan module.
2. Slowly slide in the new spine fan module.
3. Push the fan module as far as it will go, make sure the locking latches engage.

1.10.5 Management Module

Extracting a Management Module
Management modules are located on the leaf side, above the leafs. There are two places
to install the management modules.
Each management module has a pair of ejectors that lock the board in place and serve as
a lever for seating or extracting (see Figure 51).
1. Run the shut down command
down management module 2 run the command below.
switch [master] (config) # no power enable MGMT2
2. Disconnect all cables connected to the management module.
3. Push outward on the ejector handles to unlock the ejectors from the chassis.
4. Open the ejectors until they are 45 degrees from the module.
5. Pull out the module half-way through the guiding rails using the ejector handle.
6. Lock the ejector handle.
Mellanox Technologies
When hot-swapping any of the units, it is necessary to wait 1 minute after removing
the defective part before inserting the new part. This is necessary so that the manage-
ment module will start a new cycle checking through the leafs and spines for the FW
versions.
If the Fan LED continues to show red remove the fan module and check the pins on the
connector inside of the spine to make sure that none of them are bent.
When hot-swapping any of the units, it is necessary to wait 1 minute after removing
the defective part before inserting the new part. This is necessary so that the manage-
ment module will start a new cycle checking through the leafs and spines for the FW
versions.
Only one management module is required to run the switch system.
"no power enable <module>".
For example to shut
54
Rev 1.7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msx6536-nr

Table of Contents