Attach the left and right rack mount brackets (B) to the switch, by gently pushing the switch
Step 3.
chassis' pins through the slider key holes, until locking occurs. Secure the system in the
brackets by screwing the remaining 2 flat head Phillips screws (E) in the designated points
with a torque of 1.5±0.2 Nm. See
Install 8 cage nuts in the desired slots of the rack: 4 cage nuts in the non-extractable side (in
Step 4.
the top and bottom holes only) and 4 cage nuts in the extractable side.
Rev 2.2
Figure 14: Attaching the Rails to the Chassis
Figure
Figure 15: Attaching the Brackets to the Chassis
Mellanox Technologies
15.
Installation
29