Motorola WiNG 5.6 Reference Manual page 463

32. Set a NAS-Identifier Attribute
identifies where a RADIUS message originates
33. Set a NAS-Port-Id Attribute
device port where a RADIUS message originates
34. Refer to the Turn on LEDs
35. Select the Flash Pattern
behavior. Enabling this option allows an administrator to validate that the access point has received its configuration from
its managing controller during staging. In the staging process, the administrator adopts the access point to a staging
controller to get an initial configuration before the access point is deployed at its intended location. Once the access point
has received its initial configuration, its LED blinks in a unique pattern to indicate the initial configuration is complete.
36. Use the drop-down menu to configure the access point's
mobility behavior. The default is External (fixed) and indicates that the mesh point is fixed. The value vehicle-mounted
indicates that the mesh point is mobile. This feature is only available on an AP7161 model access point.
37. Use the Root Path Monitor Interval
38. Set the Additional Port
Identity Services Engine (ISE) Authentication, Authorization and Accounting (AAA) server, when deployed in the network,
to dynamically authenticate a client.
When a client requests access to the network, the CISCO ISE RADIUS server presents the client with a URL where the
device's compliance to the networks security such as validity of anti-virus or anti-spyware software is checked for the
validity for their definition files (this checking is called posture). If the client device complies, then it is allowed access to
the network.
39. Set the Aging Time value for
40. Select OK to save the changes made to the profile's Advanced Miscellaneous configuration. Select
last saved configuration.
Figure 5-254 Device Overrides - Miscellaneous screen
up to 253 characters in length. This is the RADIUS NAS-Identifier attribute that typically
up to 253 characters in length. This is the RADIUS NAS port ID attribute which identifies the
option to enable an adopted access point's LEDs. This feature is enabled by default.
radio button to enable the access point to blink in a manner different from its operational LED
to configure the interval to monitor path to the root node.
value for RADIUS Dynamic Authorization
Client Bridge. Use the spinner control to set a value in days, hours, minutes and seconds.
Meshpoint Behavior. This field configures the access point's
field. Set this value to 1700 to enable a CISCO
Device Configuration 5 - 377
Reset to revert to the