Motorola WiNG 5.6 Reference Manual page 391

54. Configure the
Null, simple-password and message-digest.
55. Refer the following to configure
Key ID
Password
56. Select OK to save the changes to the OSPF route security configuration. Select
configuration.
5.4.5.4.10Overriding a Forwarding Database Configuration
Overriding the Network Configuration
A Forwarding Database is used by a bridge to forward or filter packets. The bridge reads the packet's destination MAC address
and decides to either forward the packet or drop (filter) it. If it's determined the destination MAC is on a different network
segment, it forwards the packet to the segment. If the destination MAC is on the same network segment, the packet is dropped
(filtered). As nodes transmit packets through the bridge, the bridge updates its forwarding database with known MAC
addresses and their locations on the network. This information is then used to decide to filter or forward the packet.
This forwarding database assignment can be overridden as needed, but removes the device configuration from the managed
profile that may be shared with other similar device models.
To define or override a forwarding database configuration:
1. Select Devices
2. Select Device Overrides
3. Select a target device from the device browser in the lower, left-hand, side of the UI.
4. Select Network
5. Select Forwarding
NOTE: A blue override icon (to the left of a parameter) defines the parameter as having
an override applied. To remove an override, go to the Basic Configuration screen's Device
Overrides field and select
device.
OSPF Authentication Type
MD5 Authentication
Set the unique MD5 Authentication key ID. The available key ID range is 1-255.
Set the OSPF password. This value is displayed as "asterisk" (*). Select Show to display the
actual characters comprising the password.
from the Configuration tab.
from the Device menu to expand it into sub menu options.
to expand its sub menu options.
Database.
Clear
settings by selecting from the drop-down list. The available options are None,
keys. Click the + Add Row
Overrides. This will remove all overrides from the
Device Configuration 5 - 305
button to add a row to the table.
Reset to revert to the last saved