Motorola WiNG 5.6 Reference Manual page 428

5 - 342 WiNG 5.6 Access Point System Reference Guide
Network
Interface
Overload Type
NAT Pool
Overload IP
ACL Precedence
20. Select Add to create a new Dynamic NAT configuration,
permanently remove a configuration.
21. Set or override the following to define the
Source List ACL
Network
ACL Precedence
Displays Inside or Outside NAT as the network direction for the dynamic NAT
configuration.
Lists the VLAN (from 1 - 4094) used as the communication medium between the source
and destination points within the NAT configuration.
Options include NAT Pool, One Global Address and Interface IP Address. Interface IP
Address is the default setting.
Displays the name of an existing NAT pool used with the dynamic NAT configuration.
If One Global IP Address is selected as the Overload Type, define an IP address used as a
filter address for the IP ACL rule.
Lists the administrator assigned priority set for the listed source list ACL. The lower the
value listed, the higher the priority assigned to this ACL rule.
Figure 5-229 Device Overrides - Security - NAT - Source ACL List screen
Dynamic NAT
Use the drop-down menu to select an ACL name to define the packet selection criteria for
NAT. NAT is applied only on packets which match a rule defined in the access-list. These
addresses (once translated) will not be exposed to the outside world when the translation
address is used to interact with the remote destination.
Select Inside or Outside NAT as the network direction for the dynamic NAT configuration.
Inside is the default setting.
Set the priority (from 1 - 5000) for the source list ACL. The lower the value, the higher the
priority assigned to the ACL rule.
Edit to modify or override an existing configuration or
configuration:
Delete to