Motorola WiNG 5.6 Reference Manual page 402

5 - 316 WiNG 5.6 Access Point System Reference Guide
LLDP is neighbor discovery protocol that defines a method for network access devices using Ethernet connectivity to advertise
information about them to peer devices on the same physical LAN and store information about the network. It allows a device
to learn higher layer management and connection endpoint information from adjacent devices.
Using LLDP, an access point is able to advertise its own identification, capabilities and media-specific configuration information
and learn the same information from connected peer devices.
LLDP information is sent in an Ethernet frame at a fixed interval. Each frame contains one Link Layer Discovery Protocol Data
Unit (LLDP PDU). A single LLDP PDU is transmitted in a single 802.3 Ethernet frame.
To override a profile's LLDP configuration:
1. Select Devices
2. Select Device Overrides
3. Select a target device from the device browser in the lower, left-hand, side of the UI.
4. Select Network
5. Select Link Layer Discovery
6. Set the following LLDP parameters for the profile configuration:
Enable LLDP
Hold Time
Timer
Inventory Management
Discovery
Extended Power via MDI
Discovery
7. Select the OK
configuration.
from the Configuration tab.
from the Device menu to expand it into sub menu options.
to expand its sub menu options.
Protocol.
Figure 5-207 Link Layer Discovery Protocol (LLDP) screen
Select this option to enable LLDP on the access point. LLDP is enabled by default. When
enabled, an access point advertises its identity, capabilities and configuration information
to connected peers and learns the same from them.
Use the spinner control to set the hold time (in seconds) for transmitted LLDP PDUs. Set a
value from 10 - 1,800. The default hold time is 180 seconds.
Set the interval used to transmit LLDP PDUs. Define an interval from 5 - 900 seconds. The
default setting is 60 seconds.
Select this option to include LLPD-MED inventory management discovery TLV in LLDP
PDUs. This setting is enabled by default.
Select this option to include LLPD-MED extended power via MDI discovery TLV in LLDP
PDUs. This setting is disabled by default.
button to save the changes and overrides to the LLDP configuration. Select Reset to revert to the last saved