Motorola WiNG 5.6 Reference Manual page 556

6 - 90 WiNG 5.6 Access Point System Reference Guide
9. Refer to the Select Authentication
Security Mode
10. Set the following
Pre-Shared Key
11. Set the following
Unicast Rotation Interval
Broadcast Rotation
Interval
12. Select OK to save the changes made to the configuration. Select
13. Select the Radio Rates
Figure 6-40 MeshConnex - Security screen
field to define an authentication method for the mesh policy.
Select a security authentication mode for the mesh point. Select none to set no
authentication for the mesh point. Select psk to set a pre-shared key as the authentication
for the mesh point. If psk is selected enter a pre-shared key in the Key Settings field.
Key Settings for the mesh point:
When the security mode is set as psk, enter a 64 character HEX or an 8-63 ASCII character
passphrase used for authentication on the mesh point.
Key Rotation for the mesh point:
Define an interval for unicast key transmission in seconds (30 - 86,400).
When enabled, the key indices used for encrypting/decrypting broadcast traffic will be
alternatively rotated based on the defined interval. Define an interval for broadcast key
transmission in seconds (30 - 86,400). Key rotation enhances the broadcast traffic security
on the WLAN.
tab.
Reset to revert to the last saved configuration.