Motorola WiNG 5.6 Reference Manual page 626

8 - 12 WiNG 5.6 Access Point System Reference Guide
Stateless TCP Flow
Stateless FIN/RESET
Flow
ICMP
UDP
Any Other Flow
20. Refer to the TCP Protocol Checks
Check TCP states where
a SYN packet tears down
the flow
Check unnecessary
resends of TCP packets
Check Sequence
Number in ICMP
Unreachable error
packets
Check Acknowledgment
Number in RST packets
Check Sequence
Number in RST packets
21. Select the IPv6 Settings
Define a flow timeout value in either Seconds (1 - 32,400), Minutes (1 - 540) or
Hours (1 - 9). The default setting is 90 seconds.
Define a flow timeout value in either Seconds (1 - 32,400), Minutes (1 - 540) or
Hours (1 - 9). The default setting is 10 seconds.
Define a flow timeout value in either Seconds (1 - 32,400), Minutes (1 - 540) or
Hours (1 - 9). The default setting is 30 seconds.
Define a flow timeout value in either Seconds (15 - 32,400), Minutes (1 - 540) or
Hours (1 - 9). The default setting is 30 seconds.
Define a flow timeout value in either Seconds (1 - 32,400), Minutes (1 - 540) or
Hours (1 - 9). The default setting is 30 seconds.
field to set the following parameters:
Select the check box to allow a SYN packet to delete an old flow in TCP_FIN_FIN_STATE
and TCP_CLOSED_STATE and create a new flow. The default setting is enabled.
Select the check box to enable the checking of unnecessary resends of TCP packets. The
default setting is enabled.
Select the check box to enable sequence number checks in ICMP unreachable error
packets when an established TCP flow is aborted. The default setting is enabled.
Select the check box to enable the checking of the acknowledgment number in RST
packets which aborts a TCP flow in the SYN state. The default setting is enabled.
Select the check box to check the sequence number in RST packets which abort an
established TCP flow. The default setting is enabled.
tab.