Motorola WiNG 5.6 Reference Manual page 373

11. Refer to the Default Route Priority
Static Default Route
Priority
DHCP Client Default Route
Priority
Enable Routing Failure
12. Select the IPv6 Routing
segment to another.
Figure 5-185 Device Overrides -Static Routes screen, IPv6 Routing tab
13. Select Unicast Routing
neighbor advertisements and solicitations in unicast (as well as multicast) to provide better neighbor discovery. This setting
is enabled by default.
14. Select Unique Local Address Reject Route
15. Set a System NS Retransmit Interval
solicitation (NS) messages. NS messages are sent by a node to determine the link layer address of a neighbor, or verify a
neighbor is still reachable via a cached link-layer address. The default is 1,000 milliseconds.
field and set the following parameters:
Use the spinner control to set the priority value (1 - 8,000) for the default static route.
The default setting is 100.
Use the spinner control to set the priority value (1 - 8,000) for the default route learnt
from the DHCP client. The default setting is 1000.
When selected, all default gateways are monitored for activity. The system will failover
to a live gateway if the current gateway becomes unusable. This feature is enabled by
default.
tab. IPv6 networks are connected by IPv6 routers. IPv6 routers pass IPv6 packets from one network
to enable IPv6 unicast routing for this profile. Keeping unicast enabled allows the profile's
to enable rejecting local routes in the format FC00::/7.
(from 1,000 to 3,600,000 milliseconds) as the interval between neighbor
Device Configuration 5 - 287