Motorola WiNG 5.6 Reference Manual page 263

Figure 5-118 Mesh Point Auto Channel Selection Path Method SNR screen
11. Refer to the following for more information on the Path Method SNR screen. These descriptions apply to both the 2.4 GHz
and 5.0/4.9 GHz frequencies.
Channel Width
Priority Meshpoint
SNR Delta
Configure the channel width that mesh point automatic channel scan should assign to the
selected radio. The available options are:
• Automatic – Indicates the channel width is calculated automatically. This is the
default value.
• 20 MHz – Indicates the width between two adjacent channels is 20 MHz.
• 40 MHz – Indicates the width between two adjacent channels is 40 MHz.
Configure the mesh point monitored for automatic channel scan. This is the mesh point
given priority over other available mesh points. When configured, a mesh is created with
this mesh point. When not configured, a mesh point is automatically selected.
Configure the signal to noise ratio delta value for path selection.
When path selection happens, this value is considered for selecting the optimal path. A
better candidate on a different channel must have a signal strength that exceeds this
delta value when compared to the signal strength of the next hop in the mesh network.
Device Configuration 5 - 177