Motorola WiNG 5.6 Reference Manual page 186

5 - 100 WiNG 5.6 Access Point System Reference Guide
IPv6 Address Static
using EUI64
IPv6 Address Link
Local
34. Enable the Enforce Duplicate Address
and in a forwarding state. This option is enabled by default.
35. Refer to the IPv6 Address Prefix from Provider
Select + Add Row
Figure 5-61 Network - OSPF Virtual Interfaces - Basic Configuration screen - IPv6 tab - Add Address Prefix from Provider
Delegated Prefix
Name
Host ID
36. Select OK to save the changes to the new IPv6 prefix from provider. Select
updates.
37. Refer to the IPv6 Address Prefix from Provider EUI64
Select + Add Row
Optionally set up to 15 global IPv6 IP addresses (in the EUI-64 format) that can created
statically. The IPv6 EUI-64 format address is obtained through a 48-bit MAC address. The
MAC is initially separated into two 24-bits, with one being an OUI (Organizationally Unique
Identifier) and the other being client specific. A 16-bit 0xFFFE is then inserted between the
two 24-bits for the 64-bit EUI address. IEEE has chosen FFFE as a reserved value which can
only appear in EUI-64 generated from the an EUI-48 MAC address.
Provide the IPv6 local link address. IPv6 requires a link local address assigned to every
interface the IPv6 protocol is enabled, even when one or more routable addresses are
assigned.
option to enforce duplicate address protection when any wired port is connected
to launch a sub screen wherein a new delegated prefix name and host ID can be defined.
Enter a 32 character maximum name for the IPv6 address prefix from provider.
Define the subnet ID, host ID and prefix length.
to launch a sub screen wherein a new delegated prefix name and host ID can be defined in EUI64 format.
table to create IPv6 format prefix shortcuts as supplied by an ISP.
Exit
table to set an (abbreviated) IP address prefix in EUI64 format.
to close the screen without saving the