Profile Wired 802.1X Configuration - Motorola WiNG 5.6 Reference Manual

5 - 20 WiNG 5.6 Access Point System Reference Guide
10. Enter Controller Hostnames
following parameters to define
Host
Pool
Routing Level
IPSec Secure
IPSec GW
Force
Remote VPN Client
11. Select + Add Row
12. Select OK to save the changes made to the general profile configuration. Select
configuration.

5.2.4 Profile Wired 802.1X Configuration

System Profile Configuration
802.1X provides administrators secure, identity based access control as another data protection option to utilize with a device
profile.
802.1X is an IEEE standard for media-level (Layer 2) access control, offering the capability to permit or deny network
connectivity based on the identity of the user or device.
1. Select the Configuration
2. Select Devices.
3. Select System Profile
4. Select Wired
as needed to define resources for adoption. Click
Controller Hostnames:
Use the drop-down menu to specify whether the controller adoption resource is defined
as a (non DNS) IP address or a hostname. Once defined, provide the numerical IP or
hostname. A hostname cannot exceed 64 characters.
Use the spinner controller to set a pool of either 1 or 2. This is the pool the target Virtual
Controller belongs to. The default setting is 1.
Use the spinner controller to set the routing level for the Virtual Controller link. The
default setting is 1.
Select to enable secure communication between the access point and wireless
controllers.
Use the drop-down menu to specify if the IPSec gateway resource is defined as a (non
DNS) IP address or a hostname. Once defined, provide the numerical IP or hostname. A
hostname cannot exceed 64 characters.
Select to enable the link to the adopting controller or the controller group to be created
even when not required.
Displays whether a secure controller link has been established using a remote VPN client.
as needed to populate the table with IP addresses or hostnames of adoption resources.
tab from the Web UI.
from the options on left-hand side of the UI.
802.1x.
+Add Row to add controllers. Set the
Reset to revert to the last saved