Motorola WiNG 5.6 Reference Manual page 396

5 - 310 WiNG 5.6 Access Point System Reference Guide
11. Set or override the following
Bridging Mode
IP Outbound Tunnel
ACL
IPv6 Outbound Tunnel
ACL
MAC Outbound Tunnel
ACL
Tunnel Over Level 2
12. Set the following
Mint Link Level
Rate
Maximum Burst Size
Background
Best-effort
Video
Voice
Extended VLAN Tunnel
Specify one of the following bridging mode for use on the VLAN:
• Automatic - Select automatic mode to let the controller or service platform determine the
best bridging mode for the VLAN.
• Local - Select Local to use local bridging mode for bridging traffic on the VLAN.
• Tunnel - Select Tunnel to use a shared tunnel for bridging traffic on the VLAN.
• Isolated Tunnel - Select isolated-tunnel to use a dedicated tunnel for bridging traffic on
the VLAN.
Select an IP Outbound Tunnel ACL for outbound traffic from the drop-down menu. If an
appropriate outbound IP ACL is not available, select the Create button.
Select an IPv6 Outbound Tunnel ACL for outbound traffic from the drop-down menu. If an
appropriate outbound IPv6 ACL is not available, select the Create button.
Select a MAC Outbound Tunnel ACL for outbound traffic from the drop-down menu. If an
appropriate outbound MAC ACL is not available, select the Create button.
Select this option to allow VLAN traffic to be tunneled over level 2 links. This setting is
disabled by default.
NOTE: If creating a mesh connection between two access points in Standalone AP
mode, Tunnel must be selected as the bridging mode to successfully create the mesh link
between the two access points.
Tunnel Rate Limit parameters:
Select the MINT link level from the drop-down menu.
Define a transmit rate limit between 50 - 1,000,000 kbps. This limit constitutes a threshold
for the maximum the number of packets transmitted or received over the bridge VLAN.
Traffic that exceeds the defined rate is dropped and a log message is generated. The default
setting is 5,000 kbps.
Set a maximum burst size between 0 - 1024 kbytes. The smaller the burst, the less likely the
receive packet transmission will result in congestion. The default burst size is 320 kbytes.
Set the random early detection threshold in % for background traffic. Set a value from 1 -
100%. The default is 50%.
Set the random early detection threshold in % for best-effort traffic. Set a value from 1 -
100%. The default is 50%.
Set the random early detection threshold in % for video traffic. Set a value from 1 - 100%.
The default is 25%.
Set the random early detection threshold in % for voice traffic. Set a value from 1 - 100%.
The default is 25%.
parameters: