Motorola WiNG 5.6 Reference Manual page 175

5. Select IP Routing to enable static routes using IPv4 addresses. This option is enabled by default.
6. Select the Policy Based Routing
select the Edit icon to edit an existing policy after selecting it in the drop-down list.
7. Select Add Row + as needed to include single rows with in the static IPv4 route table.
8. Add IP addresses and network masks in the
9. Provide the Gateway used to route traffic.
10. Refer to the Default Route Priority
Static Default Route
Priority
DHCP Client Default Route
Priority
Enable Routing Failure
11. Select the IPv6 Routing
segment to another.
policy to apply to this profile. Select the
Network Address
field and set the following parameters:
Use the spinner control to set the priority value (1 - 8,000) for the default static route.
This is weight assigned to this route versus others that have been defined. The default
setting is 100.
Use the spinner control to set the priority value (1 - 8,000) for the default route learnt
from the DHCP client. The default setting is 1000.
When selected, all default gateways are monitored for activity. The system will failover
to a live gateway if the current gateway becomes unusable. This feature is enabled by
default.
tab. IPv6 networks are connected by IPv6 routers. IPv6 routers pass IPv6 packets from one network
Figure 5-52 Static Routes screen, IPv6 Routing tab
Device Configuration 5 - 89
Create icon to create a policy based route or
column of the Static Routes table.