Assembly - Chrysler Vehicle User Manual

21 - 100 AUTOMATIC TRANSMISSION - 42RLE
AUTOMATIC TRANSMISSION - 42RLE (Continued)

ASSEMBLY

NOTE: If the transmission assembly is being recon-
ditioned (clutch/seal replacement) or replaced, it is
necessary to perform the Quick Learn Procedure
using the DRBIII Scan Tool (Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL
MISSION CONTROL
PROCEDURE).
(1) Install the output bearing cups using Special
Tool - 5050A (Fig. 81).
Fig. 81 Bearing Cup Installation Special Tool -
(2) Install low/reverse piston retainer gasket (Fig.
82).
Fig. 82 Install Piston Retainer Gasket
1 - GASKET HOLES MUST LINE UP
2 - LOW/REVERSE CLUTCH PISTON RETAINER GASKET
MODULES/TRANS-
MODULE - STANDARD
5050A
(3) Install low/reverse piston retainer (Fig. 83).
Fig. 83 Install Piston Retainer
1 - LOW/REVERSE CLUTCH PISTON RETAINER
2 - GASKET
(4) Install low/reverse
screws (Fig. 84) and torque to 5 N·m (45 in. lbs.).
Fig. 84 Install Retainer Attaching Screws
1 - LOW/REVERSE CLUTCH PISTON RETAINER
2 - SCREWDRIVER
3 - TORX-LOC SCREWS
TJ
piston retainer-to-case