Chrysler Vehicle User Manual page 1251

21 - 114 AUTOMATIC TRANSMISSION - 42RLE
AUTOMATIC TRANSMISSION - 42RLE (Continued)
(42) Install transmission oil filter (Fig. 134).
Tighten the bolts to 5 N·m (45 in. lbs.)
Fig. 134 Install Transmission Filter
1 - TRANSMISSION FILTER
(43) Install transmission oil pan (Fig. 135) with a
bead of Mopar ATF RTV (MS-GF41). Torque oil pan-
to-case bolts to 20 N·m (14.5 ft. lbs.).
Fig. 135 Install Transmission Oil Pan
1 - TRANSMISSION OIL PAN
(44) Install both speed sensors into transmission
case (Fig. 136). Torque the speed sensor bolts to 9
N·m (80 in. lbs.).
(45) As a final check of the transmission, measure
the input shaft end play. This will indicate when a #4
thrust plate change is required. The #4 thrust plate
is located behind the overdrive clutch hub. Attach a
dial indicator to transmission bell housing with its
plunger seated against end of input shaft (Fig. 137).
Move input shaft in and out to obtain end play read-
ing. End play specifications are 0.13 to 0.64 mm
(0.005 to 0.025 inch). If not within specifications,
make the necessary thrust plate adjustment.
Fig. 136 Input and Output Speed Sensors and
Transmission Range Sensor
1 - INPUT SPEED SENSOR
2 - OUTPUT SPEED SENSOR
3 - TRANSMISSION RANGE SENSOR
Fig. 137 Measure Input Shaft End Play Using Tool
8266 - Typical
1 - TOOL 8266-8
2 - TOOL 8266-2
3 - TOOL C-3339
(46) Inspect the lube tube grommet (Fig. 138) for
damage. If the grommet lip is damaged, it will need
to be replaced.
(47) Install the 4X4 stub shaft onto the transmis-
sion output shaft.
(48) Place a bead of Mopar ATF RTV (MS-GF41)
on the rear surface of the transmission case for the
adapter housing.
TJ