Chrysler Vehicle User Manual page 1390

TJ
TRANSFER CASE - NV241 (Continued)
Fig. 86 Rear Extension Bolt Installation
1 - EXTENSION HOUSING
2 - BOLTS
Fig. 87 Speedometer Sensor Installation
1 - EXTENSION HOUSING
2 - SPEEDOMETER SENSOR
INSTALLATION
(1) Align and seat transfer case on transmission.
Be sure transfer case input gear splines are aligned
with transmission output shaft. Align splines by
rotating transfer case rear output shaft yoke if nec-
essary. Do not install any transfer case attaching
nuts until the transfer case is completely seated
against the transmission.
(2) Install and tighten transfer case attaching
nuts. Tighten nuts to 30-41 N·m (20-30 ft.lbs.).
(3) Install rear crossmember.
(4) Remove jack stand from under transmission.
(5) Align and connect propeller shafts. (Refer to 3 -
DIFFERENTIAL &
SHAFT/PROPELLER SHAFT - INSTALLATION)
(6) Connect vacuum harness and vent hose.
DRIVELINE/PROPELLER
TRANSFER CASE - NV241
Fig. 88 Speedometer Sensor Bolt Installation
1 - EXTENSION HOUSING
2 - BOLT
3 - SPEEDOMETER SENSOR
Fig. 89 Rear Companion Flange Nut Removal
1 - TRANSFER CASE
2 - HOLDER 6719
3 - COMPANION FLANGE
4 - BOLTS
(7) Connect shift rod to transfer case lever or floor
shift arm. Use channel lock style pliers to press rod
back into lever grommet.
(8) Adjust shift linkage, if necessary.
(9) Fill transfer case with recommended transmis-
sion fluid and install fill plug.
(10) Install skid plate, if equipped. (Refer to 13 -
FRAMES & BUMPERS/FRAME/TRANSFER CASE
SKID PLATE - INSTALLATION)
(11) Lower vehicle
21 - 253