Chrysler Vehicle User Manual page 1483

23 - 70 SEATS
FRONT SEAT BACK COVER (Continued)
(8) Remove the seat cover and cushion.
Fig. 5 FORWARD FOLDING SEAT RELEASE
1 - SEAT BACK
2 - BEZEL SCREW
3 - RELEASE HANDLE BEZEL
4 - RELEASE HANDLE KNOB
INSTALLATION
(1) Position cover and cushion on seatback.
(2) Install the release handle bezel and install the
screw.
(3) Install the release handle knob.
(4) Install the support rods.
(5) Install the upper hog rings.
(6) Install the bottom hog rings.
(7) Connect the j-straps at the bottom of the seat
back.
(8) Install seat back. (Refer to 23 - BODY/SEATS/
FRONT SEAT BACK - INSTALLATION)
FRONT SEAT CUSHION COVER
REMOVAL
(1) Remove seat back. (Refer to 23 - BODY/SEATS/
FRONT SEAT BACK - REMOVAL)
(2) Disengage inboard j-strap.
(3) Disengage front j-strap.
(4) Disengage rear j-strap
(5) Roll cover up to access hog rings.
(6) Disengage inboard and outboard hog rings.
(7) Separate cover from cushion.
INSTALLATION
(1) Position cover on cushion and align seams.
(2) Engage inboard and outboard hog rings.
(3) Roll cover over cushion edges.
(4) Engage inboard j-strap.
(5) Engage front j-strap.
HANDLE
(6) Engage rear j-strap
(7) Install seat back. (Refer to 23 - BODY/SEATS/
FRONT SEAT BACK - INSTALLATION)
FRONT SEAT BACK RECLINER/
COVER
REMOVAL
(1) Remove the seat. (Refer to 23 - BODY/SEATS/
FRONT SEAT - REMOVAL)
(2) Disconnect the j-straps at the lower edge of the
seat back and position aside.
(3) Disconnect the rear j-straps of the cushion and
position aside.
(4) Using a small flat bladed tool, release the
recliner cover retaining tab and remove. (Fig. 3)
(5) Disconnect the seat back dump cables. (Fig. 4)
(6) Remove the two seat back bolts.
(7) Remove the two seat cushion frame bolts.
(8) Disconnect the recliner cable.
(9) For the inboard recliner, disconnect the forward
folding cable assembly, if equipped.
INSTALLATION
(1) Connect the forward folding cable assembly, if
equipped.
(2) Connect the recliner cable.
(3) Install the two seat cushion frame bolts.
(4) Install the two seat back bolts.
(5) Connect the seat back dump cables.
(6) Install the recliner cover.
(7) Connect the rear j-straps of the cushion.
(8) Connect the j-straps at the lower edge of the
seat back.
(9) Install the seat. (Refer to 23 - BODY/SEATS/
SEAT - INSTALLATION)
FRONT SEAT BACK RECLINER
CABLE
REMOVAL
(1) Remove seat cushion cover. (Refer to 23 -
BODY/SEATS/SEAT
REMOVAL)
(2) Disengage cable from recliner release handle.
(Fig. 6) and (Fig. 7)
(3) Route cable through seat cushion pad.
(4) Disengage cable from mounting bracket.
INSTALLATION
(1) Engage cable to mounting bracket.
(2) Route cable through seat cushion pad.
(3) Engage cable to recliner release.
CUSHION COVER
TJ
-