Chrysler Vehicle User Manual page 1369

21 - 232 TRANSFER CASE - NV241
TRANSFER CASE - NV241 (Continued)
REAR EXTENSION, RETAINER, AND REAR CASE
(1) Install bolts into two threaded holes in the rear
propeller shaft companion flange 180° apart (Fig. 3).
(2) Place the Holder 6719 (Fig. 3) over the two
bolts and use the Holder to remove the rear compan-
ion flange nut.
Fig. 3 Rear Companion Flange Nut Removal
1 - TRANSFER CASE
2 - HOLDER 6719
3 - COMPANION FLANGE
4 - BOLTS
(3) Remove the rear companion flange from the
output shaft.
NOTE: The companion flange is a taper fit onto the
output shaft. It may be necessary to use Puller 8992
to remove the companion flange.
(4) There is a seal slinger located on the rear of
the companion flange that can be replaced if neces-
sary. Use a suitable cold chisel to strike the slinger
hub parallel to the centerline in several spots to
expand the slinger hub. A new slinger can be driven
onto the flange hub using a suitable pipe tool.
(5) Remove the speedometer sensor bolt (Fig. 4).
(6) Remove the speedometer sensor (Fig. 5) from
the extension housing.
Fig. 4 Speedometer Sensor Bolt Removal
1 - EXTENSION HOUSING
2 - BOLT
3 - SPEEDOMETER SENSOR
Fig. 5 Speedometer Sensor Removal
1 - EXTENSION HOUSING
2 - SPEEDOMETER SENSOR
TJ