TJ
TRANSFER CASE - NV241 (Continued)
Fig. 55 Front Input Retainer Bolt Installation
1 - INPUT RETAINER
2 - INPUT GEAR
3 - BOLT
4 - FRONT CASE HALF
(8) Install the input gear to the low range plane-
tary assembly and the input gear bearing.
(9) Install the input gear retaining snap-ring (Fig.
56) onto the input gear.
(10) Install new oil seal in front input retainer
with Installer 8841 and Handle C-4171 (Fig. 57).
Fig. 56 Input Gear Snap-Ring Installation
1 - INPUT RETAINER
2 - INPUT GEAR
3 - SNAP-RING
TRANSFER CASE - NV241
Fig. 57 Input Gear Seal Installation
1 - HANDLE C-4171
2 - INSTALLER 8841
3 - INPUT RETAINER
SHIFT FORKS AND MAINSHAFT
(1) Lubricate mainshaft splines with recommended
transmission fluid.
(2) Install the drive sprocket drive hub onto the
mainshaft (Fig. 58). Verify that the long shoulder is
towards the front of the mainshaft.
Fig. 58 Drive Sprocket Drive Hub Installation
1 - MAINSHAFT
2 - DRIVE SPROCKET DRIVE HUB
21 - 245