Chrysler Vehicle User Manual page 1442

TJ
LEFT FRONT FENDER (Continued)
1 - REINFORCEMENT
2 - BATTERY TRAY
3 - BODY
4 - REINFORCEMENT
(11) Install EVAP canister.
(12) Install horns. (Refer to 8 - ELECTRICAL/
HORN/HORN - INSTALLATION)
(13) Engage horn wire connectors.
(14) Install the windshield washer reservoir.
(15) Connect the negative terminal on the battery.
(Refer to 8 - ELECTRICAL/BATTERY SYSTEM/CA-
BLES - INSTALLATION)
RADIATOR GRILLE PANEL
REMOVAL
(1) Remove the front crossmember cover.
(2) Remove the crossmember valence cover.
(3) Remove the radiator overflow bottle.
(4) Remove the bolts that attach the radiator and
shroud from the grille panel.
(5) If A/C equipped:
(a) Evacuate the system.
(b) Disconnect the high and low pressure lines
at the quick disconnect couplings.
(c) Cover (cap) the lines to prevent contamina-
tion.
Fig. 3 FRONT FENDER
5 - FENDER
6 - TRAY
7 - RADIATOR GRILLE PANEL
(6) Remove the bolts attaching the radiator sup-
port rods to the grille panel.
(7) Disconnect the head lamp, turn signal, marker
lamp and horn wire harness connectors.
(8) Remove the bolts attaching the fenders to the
grille panel.
(9) Remove the bolt attaching the grille to the
frame mount.
(10) Separate the grille from the vehicle.
INSTALLATION
Transfer all related components.
(1) Position the grille panel on the vehicle. Ensure
the rubber support bumpers are aligned (Fig. 4).
(2) Install the bolt attaching the grille to the frame
mount.
(3) Install the bolts attaching the fenders to the
grille panel.
(4) Connect the head lamp, turn signal, marker
lamp and horn wire harness connectors.
(5) Install the bolts attaching the radiator support
rods to the grille panel.
(6) If A/C equipped:
(a) Connect the high and low pressure lines at
the quick disconnect couplings.
EXTERIOR 23 - 29