21 - 234
TRANSFER CASE - NV241
TRANSFER CASE - NV241 (Continued)
Fig. 10 Front Yoke Removal
1 - TRANSFER CASE
2 - FRONT YOKE
(4) There is a seal slinger located on the rear of
the yoke that can be replaced if necessary. Use a
suitable cold chisel to strike the slinger hub parallel
to the centerline in several spots to expand the
slinger hub. A new slinger can be driven onto the
yoke hub using a suitable pipe tool.
(5) Remove yoke rubber seal from front output
shaft.
(6) Remove bolt (Fig. 11) that retains the shift
lever to sector shaft.
(7) Remove the shift lever (Fig. 12) from the shift
sector.
Fig. 11 Shift Lever Bolt Removal
1 - SHIFT LEVER
2 - BOLT
3 - SECTOR SUPPORT
Fig. 12 Shift Lever Removal
1 - SHIFT LEVER
2 - SECTOR SUPPORT
3 - SHIFT SECTOR
(8) Remove the detent plug (Fig. 13).
(9) Remove the detent plug (Fig. 14), spring, and
plunger from the transfer case.
Fig. 13 Detent Plug Removal
1 - DETENT PLUG
2 - SPRING
TJ