Chrysler Vehicle User Manual page 1472

TJ
REAR HEADER TRIM
REMOVAL
(1) Disconnect the rear window defogger electrical
connectors, if equipped.
(2) Remove the wiper motor cover and disconnect
the wiper motor electrical connector and washer
hose. (Fig. 14)
Fig. 14 REAR WIPER MOTOR TRIM COVER
REMOVE/INSTALL
1 - SCREW (3)
2 - TRIM COVER
3 - ELECTRICAL & WASHER HOSE CONNECTIONS
4 - WIPER MOTOR
5 - LIFTGATE GLASS
(3) Using a trim stick C-4755 or equivalent, sepa-
rate the header trim and retainer clips from the top.
(Fig. 15)
(4) Pull the wire harnesses and washer hose
through the trim panel and remove.
INSTALLATION
(1) Route the wire harnesses and washer hose
through the trim panel.
(2) Install the header trim and seat the retaining
clips fully.
(3) Connect the wiper motor electrical and the
washer hose connection.
(4) Connect the rear window defogger electrical
connectors, if equipped.
Fig. 15 REAR HEADER TRIM
1 - REAR HEADER TRIM
2 - WIRE OPENINGS (2)
WINDSHIELD HEADER
REMOVAL
(1) Position both sun visors out.
(2) Using a trim stick C-4755 or equivalent, sepa-
rate the retaining clips and remove the trim from
behind the a-pillar trim panels.
Fig. 16 WINDSHIELD HEADER MOLDING
1 - WINDSHIELD HEADER TRIM
2 - WINDSHIELD FRAME
3 - SPRING CLIPS (4)
INSTALLATION
(1) Install the windshield header trim and position
the end tabs behind the a-pillar trim.
(2) Seat the retaining clips fully.
INTERIOR 23 - 59