Chrysler Vehicle User Manual page 1434

TJ
LATCH STRIKER (Continued)
INSTALLATION
(1) Position the striker and the spacer on the body.
(2) Install the screws attaching the striker and
spacer to the body.
LOCK CYLINDER
REMOVAL
(1) Remove trim panel. (Refer to 23 - BODY/FULL
DOOR/TRIM PANEL - REMOVAL)
(2) Peel back waterdam.
(3) Disconnect lock cylinder to latch rod.
(4) Remove lock cylinder retaining clip.
(5) Remove the lock cylinder from the door.
INSTALLATION
(1) Install the lock cylinder in the door.
(2) Install lock cylinder retaining clip.
(3) Connect lock cylinder to latch rod.
(4) Secure the waterdam to the door.
(5) Install trim panel. (Refer to 23 - BODY/FULL
DOOR/LOCK CYLINDER - INSTALLATION)
TRIM PANEL
REMOVAL
(1) Lower the window.
(2) Remove the clip attaching the window glass
regulator handle to the regulator. Remove the han-
dle.
(3) Remove the screws attaching trim panel to
door (Fig. 13).
(4) Using a special tool C-4829 or equivalent,
remove push-in fasteners attaching trim panel to
door.
(5) Lift the trim panel upward and separate the
trim panel from the door.
Fig. 13 FULL
1 - FULL DOOR
2 - GRAB HANDLE BRACKET
3 - TRIM PANEL
4 - NUT
INSTALLATION
(1) Position the trim panel on the door.
(2) Press the push-in fasteners attaching trim
panel to door into place.
(3) Install the screws attaching trim panel to door.
(4) Position the clip on regulator handle and
install the handle on the regulator.
FULL DOOR 23 - 21