Chrysler Vehicle User Manual page 1330

TJ
VALVE BODY (Continued)
INSTALLATION
(1) Install valve body into position and start bolts.
Torque valve body to transmission case bolts (Fig.
301) to 12 N·m (105 in. lbs.) torque.
Fig. 301 Install Valve Body Bolts
1 - BOLTS
(2) Install transmission oil filter (Fig. 302).
Fig. 302 Install Transmission Filter
1 - TRANSMISSION FILTER
AUTOMATIC TRANSMISSION - 42RLE
(3) Make sure oil pan and case rail are clean and
dry. Install an 1/8" bead of RTV to the transmission
oil pan and install to case. Tighten bolts (Fig. 303) to
20 N·m (14.5 ft. lbs.).
Fig. 303 Install Transmission Oil Pan Bolts
1 - TRANSMISSION OIL PAN
2 - BOLTS
(4) Lower vehicle and connect the TRS connector.
(5) Connect solenoid/pressure switch assembly con-
nector.
(6) Lower vehicle.
(7) Fill transmission
Transmission Fluid. Verify proper fluid level. (Refer
to 21 - TRANSMISSION/AUTOMATIC - 42RLE/
FLUID - STANDARD PROCEDURE)
NOTE: If the valve body has been reconditioned or
replaced, it is necessary to perform the Quick Learn
Procedure. (Refer to 8 - ELECTRICAL/ELECTRONIC
CONTROL MODULES/TRANSMISSION
MODULE - STANDARD PROCEDURE)
21 - 193
with ATF+4, Automatic
CONTROL