Chrysler Vehicle User Manual page 1433

23 - 20 FULL DOOR
INSIDE HANDLE ACTUATOR (Continued)
(3) Disconnect the latch rods from the handle
(Fig. 10).
Fig. 10 INSIDE HANDLE ACTUATOR
1 - LOCK KNOB TO LATCH ROD
2 - U-NUT
3 - HALF DOOR TRIM PANEL
4 - INSIDE RELEASE HANDLE TO LATCH ROD
INSTALLATION
(1) Connect the latch rods to the handle.
(2) Position handle and seal in door.
(3) Install the torx screw attaching the inside han-
dle the to door.
LATCH
REMOVAL
(1) Remove trim panel. (Refer to 23 - BODY/FULL
DOOR/TRIM PANEL - REMOVAL)
(2) Roll window to full upward position.
(3) Disconnect the lock cylinder to latch rod.
(Fig. 11)
(4) Disconnect the lock knob to latch rod.
(5) Disconnect the outside handle to latch release
rod.
(6) Remove the screws attaching the latch to the
door.
(7) Lower the latch in the door and disconnect the
inside handle to latch rod.
(8) Remove the latch from the door.
INSTALLATION
(1) Position the latch in the door.
(2) Connect the inside handle to latch rod.
(3) Install the screws attaching the latch to the
door.
(4) Position the door weatherstrip in place, apply
adhesive as necessary.
(5) Connect the outside handle to latch rod.
Fig. 11 DOOR LATCH ASSEMBLY
1 - RELEASE ROD
2 - SCREWS (3)
3 - LATCH ASSEMBLY
4 - LOCK ROD
(6) Connect the lock knob to latch rod.
(7) Connect the lock cylinder to latch rod.
(8) Install trim panel. (Refer to 23 - BODY/FULL
DOOR/TRIM PANEL - INSTALLATION)
LATCH STRIKER
REMOVAL
(1) Remove the screws attaching the striker to the
body.
(2) Separate the striker and the spacer from the
body (Fig. 12).
Fig. 12 LATCH STRIKER
1 - STRIKER
2 - SPACER
3 - BODY
TJ