Chrysler Vehicle User Manual page 1436

TJ
EXTERIOR HANDLE
REMOVAL
(1) Remove trim panel. (Refer to 23 - BODY/HALF
DOOR/TRIM PANEL - REMOVAL)
(2) Disconnect the outside handle to latch rod.
(3) Remove screws attaching the outside handle to
the door.
(4) Separate the outside handle and seal from the
door.
INSTALLATION
(1) Position the outside handle and seal in the
door.
(2) Install screws attaching the outside handle to
the door.
(3) Connect the outside handle to latch rod.
(4) Install trim panel. (Refer to 23 - BODY/HALF
DOOR/TRIM PANEL - INSTALLATION)
HINGE
DESCRIPTION
The service procedures for the half door hinge are
the same as the full door hinge. (Refer to 23 - BODY/
FULL DOOR/HINGE - REMOVAL) and (Refer to 23 -
BODY/FULL DOOR/HINGE - INSTALLATION).
INSIDE HANDLE ACTUATOR
REMOVAL
(1) Remove the torx screw attaching the inside
handle to the door.
(2) Carefully pull handle from door.
(3) Disconnect the latch rods from the handle (Fig.
3).
Fig. 3 INSIDE HANDLE ACTUATOR
1 - LOCK KNOB TO LATCH ROD
2 - U-NUT
3 - HALF DOOR TRIM PANEL
4 - INSIDE RELEASE HANDLE TO LATCH ROD
INSTALLATION
(1) Connect the latch rods to the handle.
(2) Position handle and seal in door.
(3) Install the torx screw attaching the inside han-
dle the to door.
HALF DOOR 23 - 23