Chrysler Vehicle User Manual page 1478

TJ
HARD TOP (Continued)
Fig. 1 HARD TOP LATCH
1 - LATCH
2 - HARD TOP
3 - WINDSHIELD FRAME
Fig. 2 HARD TOP REMOVAL
1 - HARD TOP
2 - HOLD DOWN BOLT
3 - BODY RAIL
Fig. 3 REAR WIPER WIRE HARNESS CONNECTOR
1 - WIPER MOTOR CONNECTOR
Fig. 4 REAR WASHER FLUID TUBE
1 - WASHER HOSE CAP
2 - REAR WASHER SUPPLY HOSE - BODY HALF
(3) Carefully position the hard top assembly on the
vehicle making sure that the latches are not pinched
between the windshield frame and top.
CAUTION: Do not over tighten the top bolts. Over
tightening can cause cracking of the hardtop
assembly.
(4) Loosely install the six bolts. Ensure that the
top is centered on the vehicle and tighten the bolts to
17 N·m (150 in. lbs.).
(5) Connect the wire wiper motor harness connector.
(6) Connect the rear washer fluid hose.
(7) Engage the latches at windshield frame and
snap the clamps home.
SOFT TOP
REMOVAL
(1) Disengage the retainers attaching the rear win-
dow to the body.
(2) Remove rear window, unzipping from right to left.
(3) Disengage J-straps at soft top rear corners
(Fig. 5).
(4) Unzip quarter windows, disengage J-strap and
remove quarter windows.
(5) Starting at the rear of the upper door opening
frame and working forward, disengage drip rail retain-
ers attaching the soft top to the door opening frame.
(6) Unlatch top at windshield frame.
(7) Lower the top to the rearward position.
(8) Remove the screws attaching the roof bows to
the pivot bracket (Fig. 6).
(9) Lift up bows at pivot bracket to disengage from
pivot bracket.
(10) Remove the top (Fig. 7).
REMOVEABLE TOP 23 - 65