Configuring Nat Ip - Zte ZXR10 8900 Series User Manual

S Command
teps
1
ZXR10(config)#fw
2
ZXR10(config-fw)#fw-template<
template-id >
3
ZXR10(config-fw-template-1)#bind<
slot-number >
4
ZXR10(config-fw)#show fw-template
<template-id>
To bind slot 8 with fw-template10 (fw is inserted in slot 8), execute
Example
the following command:
ZXR10(config)#fw ZXR10(config-fw)#fw-template 10
ZXR10(config-fw-templete-10)#bind slot 8

Configuring NAT IP

This topic describes how to specify IP POOL for NAT function.
S Command
tep
1
ZXR10(config)#fw
2
ZXR10(config-fw)#fw-template<
template-id >
3
ZXR10(config-fw-template-1)#nat
dip< ipaddr >< ipmask >
4
ZXR10(config-fw-template-1)#nat
sip< ipaddr >< ipmask >
Chapter 4 ZXR10 FW Function Management
Confidential and Proprietary Information of ZTE CORPORATION
Function
This enters FW
configuration mode
(used in configure
terminal mode)
This accesses
fw-template node
(used in fw
configuration mode).
This binds slot
number (used
in fw-template
configuration mode).
This shows if
fw-template
is successfully
configured (used
in any mode of main
board).
Function
This enters FW
configuration mode
(used in configure
terminal mode)
This accesses
fw-template node
(used in fw
configuration mode).
This specifies one
destination nat
address (used
in fw-template
configuration mode).
This specifies one
source nat address
(used in fw-template
configuration mode).
61