Defining Function Toggle Actions - GE Ultrasonic USM Go Operator's Manual

2.3.3 Defining Function Toggle Actions

The user can specify a desired action to occur when either end of the Function Toggle (
user-specified function action is ignored, however, whenever a parameter is selected and its value is being edited.
In the SETUP menu, activate the CONFIG2 submenu using the joystick (
1.
2. Use the joystick (
function titled FUNCTION2, for the end of the toggle further from the display screen. Then, press the center of the joystick (
activate the function.
Note: There are two values for each function. The upper parameter determines the action taken when then corresponding toggle end is
momentarily pressed. The lower parameter defines the action taken when the toggle end is pressed and held.
3. To change the upper parameter, move the joystick left or right (
USM Go Operator's Manual
) to select either the function titled FUNCTION1, for the end of the toggle closer to the display screen, or the
) is pressed or pressed-and-held. The
). Several functions are displayed on the screen.
).
Chapter 2. Instrument Setup
) to
35