Connecting The I/O Port - GE Ultrasonic USM Go Operator's Manual

Chapter 1. General Information

1.5.4 Connecting the I/O Port

The connector furthest from the hinge of the top compartment cover (see Figure 5 on page 13) is an I/O port. This port serves a dual role:
•
Serial port pins - these are used strictly for factory service diagnostics.
•
Sync & Alarm pins - these signals are accessible to the user via a special optional cable.
To use this connector you must order the optional USM Go cable, which is available as P/N 022-510-032. The pin designations for
connecting the open end of this cable are listed in Table 1 below:
16
Table 1: I/O Connector Pin Assignments
Pin # Color
1 Brown
2 Red
3 Orange
4 Yellow
5 Green
6 Blue
7 Purple
Signal
+5V
SAP
Alarm
RS232 CTS
RS232 TX
RS232 RX
GND
USM Go Operator's Manual