Chapter 5. Data Recorder Files
5.1
Naming the Data Recorder File
In the SETUP menu, use the joystick (
below to either create a new file name or select an existing file name.
5.1.1
File Selection Mode
1.
Use the joystick (
(
) to activate the function in File Selection mode.
2.
Move the joystick up or down (
3.
Press the center of the joystick (
128
) to activate the DR menu (see Figure 16 on page 127). Then, proceed to the appropriate section
) to select the function titled FILENAME in the DR SETUP submenu. Press the center of the joystick once
) to select the desired file name from the list of SD card files.
) to deactivate the function.
USM Go Operator's Manual