Table of Contents
Advertisement
Chapter 2. Instrument Setup
2.4.2c
Changing Damping Level to modify the Signal to Noise Ratio
In the ACQUIRE menu, activate the PULSER submenu using the joystick (
1.
2.
Use the joystick (
3.
To change the specified damping level and optimize the A-Scan signal appearance, move the joystick (
toggle. The following options are available:
50
•
1000
•
4.
After completing your selection, move the joystick up or down (
40
) to select the function titled DAMPING.
(PULSER-DAMPING)
).
) to navigate away from this function.
) or press the function
USM Go Operator's Manual
Advertisement
Table of Contents
