Setting The User-Defined Gain Step (Setup-Gain-User Gain Step) - GE Ultrasonic USM Go Operator's Manual

3.5.2

Setting the User-Defined Gain Step (SETUP-GAIN-USER GAIN STEP)

When adjusting the A-Scan gain, each press of the Gain Toggle increases or decreases the gain level by the amount of the dB STEP. To
enter a user-specified gain step, known as USER GAIN STEP, complete the following steps:
1. In the SETUP menu, activate the CONFIG2 submenu using the joystick (
2. Use the joystick (
function.
3. Move the joystick left or right (
dB STEP function is activated.
4. After making your choice, press the center of the joystick (
USM Go Operator's Manual
) to select the function titled USER GAIN STEP. Press the center of the joystick (
) to change the value of USER GAIN STEP. This value is now available as an option whenever the
).
) to deactivate the function.
Chapter 3. Making Measurements
) to activate the
81